Jasper Sikken
This program displays heart rate and time between heart beats on LCD, prints it to a USB serial port, print it to a bluetooth serial port and store it on a USB mass storage device. The program has two interrupt routines: 1.Every 1ms a counter is increased with one, 2. On every heart beat the counter is value copied. In the main loop the beats per minute are calculated. Ext.Modules:- Polar RMCM-01 heart rate module connected to pin8. - 2x16 LCD - a RF-BT0417CB bluetooth serial device connected to p27 and p28 - an USB mass storage device
USBHostLite/usbhost_err.h
- Committer:
- jrsikken
- Date:
- 2011-01-04
- Revision:
- 2:e660e68a91fa
- Parent:
- 1:8b001f936bb0
File content as of revision 2:e660e68a91fa:
/*
**************************************************************************************************************
* NXP USB Host Stack
*
* (c) Copyright 2008, NXP SemiConductors
* (c) Copyright 2008, OnChip Technologies LLC
* All Rights Reserved
*
* www.nxp.com
* www.onchiptech.com
*
* File : usbhost_err.h
* Programmer(s) : Ravikanth.P
* Version :
*
**************************************************************************************************************
*/
#ifndef USBHOST_ERR_H
#define USBHOST_ERR_H
/*
**************************************************************************************************************
* GENERAL DEFINITIONS
**************************************************************************************************************
*/
#define OK 0
#define MATCH_FOUND 0
/*
**************************************************************************************************************
* HOST CONTROLLER SPECIFIC ERROR CODES
**************************************************************************************************************
*/
#define ERR_TD_FAIL -1
/*
**************************************************************************************************************
* MASS STORAGE SPECIFIC ERROR CODES
**************************************************************************************************************
*/
#define ERR_MS_CMD_FAILED -10
#define ERR_BAD_CONFIGURATION -11
#define ERR_NO_MS_INTERFACE -12
/*
**************************************************************************************************************
* FAT SPECIFIC ERROR CODES
**************************************************************************************************************
*/
#define MATCH_NOT_FOUND -20
#define ERR_FAT_NOT_SUPPORTED -21
#define ERR_OPEN_LIMIT_REACHED -22
#define ERR_INVALID_BOOT_SIG -23
#define ERR_INVALID_BOOT_SEC -24
#define ERR_ROOT_DIR_FULL -25
#endif