Diff: targets/hal/TARGET_Atmel/TARGET_SAM21/drivers/system/pinmux/quick_start/qs_pinmux_basic.h

Revision:

613:bc40b8d2aec4

Parent:

612:fba1c7dc54c0

Child:

614:9d86c2ae5de0

--- a/targets/hal/TARGET_Atmel/TARGET_SAM21/drivers/system/pinmux/quick_start/qs_pinmux_basic.h	Tue Aug 18 15:00:09 2015 +0100
+++ /dev/null	Thu Jan 01 00:00:00 1970 +0000
@@ -1,53 +0,0 @@
-/**
- * \page asfdoc_sam0_system_pinmux_basic_use_case Quick Start Guide for SYSTEM PINMUX - Basic
- *
- * In this use case, the PINMUX module is configured for:
- *  \li One pin in input mode, with pull-up enabled, connected to the GPIO
- *      module
- *  \li Sampling mode of the pin changed to sample on demand
- *
- * This use case sets up the PINMUX to configure a physical I/O pin set as
- * an input with pull-up and changes the sampling mode of the pin to reduce
- * power by only sampling the physical pin state when the user application
- * attempts to read it.
- *
- * \section asfdoc_sam0_system_pinmux_basic_use_case_setup Setup
- *
- * \subsection asfdoc_sam0_system_pinmux_basic_use_case_setup_prereq Prerequisites
- * There are no special setup requirements for this use-case.
- *
- * \subsection asfdoc_sam0_system_pinmux_basic_use_case_setup_code Code
- * Copy-paste the following setup code to your application:
- * \snippet qs_pinmux_basic.c setup
- *
- * \subsection asfdoc_sam0_system_pinmux_basic_use_case_setup_flow Workflow
- * -# Create a PINMUX module pin configuration struct, which can be filled out
- *    to adjust the configuration of a single port pin.
- *    \snippet qs_pinmux_basic.c pinmux_config
- * -# Initialize the pin configuration struct with the module's default values.
- *    \snippet qs_pinmux_basic.c pinmux_config_defaults
- *    \note This should always be performed before using the configuration
- *          struct to ensure that all values are initialized to known default
- *          settings.
- *
- * -# Adjust the configuration struct to request an input pin with pullup
- *    connected to the GPIO peripheral.
- *  \snippet qs_pinmux_basic.c pinmux_update_config_values
- * -# Configure GPIO10 with the initialized pin configuration struct, to enable
- *    the input sampler on the pin.
- *    \snippet qs_pinmux_basic.c pinmux_set_config
- *
- * \section asfdoc_sam0_system_pinmux_basic_use_case_use_main Use Case
- *
- * \subsection asfdoc_sam0_system_pinmux_basic_use_case_code Code
- * Copy-paste the following code to your user application:
- * \snippet qs_pinmux_basic.c main
- *
- * \subsection asfdoc_sam0_system_pinmux_basic_use_case_flow Workflow
-
- * -# Adjust the configuration of the pin to enable on-demand sampling mode.
- *    \snippet qs_pinmux_basic.c pinmux_change_input_sampling
- */
-/**
-* Support and FAQ: visit <a href="http://www.atmel.com/design-support/">Atmel Support</a>
-*/