Reply to
Why is the mbed so bloody slow?: The I/O is pretty slow, the ugly routine below generates a square wave of about ...
Rocky Lavine - 1 hour, 42 minutes ago
New topic
Hello: I am an author for Nuts N Volts and Servo magazine. I am planning on ...
mike keesling - 1 hour, 56 minutes ago
Reply to
Interrupt response time: It is almost as if the interrupts are being clocked before being read by the ...
John Robbins - 5 hours, 10 minutes ago
Reply to
Interrupt response time: It's actually supposed to jump to after the if, but since that's the end of ...
Igor Skochinsky - 5 hours, 27 minutes ago
Reply to
Interrupt response time: Thanks for the code sample, most helpful but I _really_ now don't understand the delay ...
John Robbins - 5 hours, 37 minutes ago
Reply to
Interrupt response time: Thanks again for your patience. Looking at the circuit and the board itself, it does ...
John Robbins - 5 hours, 52 minutes ago
Reply to
Interrupt response time: For what it's worth, here's the assembly generated for your loop (with my comments): LDR ...
Igor Skochinsky - 6 hours, 1 minute ago
Reply to
Interrupt response time: I am not sure whether it will be faster. On the one hand, the handler ...
Igor Skochinsky - 6 hours, 14 minutes ago
Reply to
Interrupt response time: Sorry for the above posts - my mouse must have jumped. So once again Thanks ...
John Robbins - 6 hours, 16 minutes ago
Reply to
interfacing with USBD480 lcd controller: Thnkx. There are no other interfaces on the controller board...
Kartik Jangam - 6 hours, 18 minutes ago
Reply to
Interrupt response time: Thanks for the pointer. Would using the handler be any faster? At the moment, a ...
John Robbins - 6 hours, 31 minutes ago
Reply to
Interrupt response time: Thanks for the pointer. Would using the handler be any faster? At the moment, a ...
John Robbins - 6 hours, 31 minutes ago
Reply to
Interrupt response time: Sorry, I was unclear. I mean that EINT3 vector is also used for GPIO interrupts ...
Igor Skochinsky - 6 hours, 55 minutes ago
Reply to
Interrupt response time: Hi Igor, Thanks for the reply. Are the EINT pins actually accessible on the mbed ...
John Robbins - 7 hours, 8 minutes ago
Reply to
Interrupt response time: Not sure if this is the issue, but try using an actual interrupt handler instead ...
Igor Skochinsky - 8 hours, 5 minutes ago