Important changes to forums and questions
All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.
9 years, 7 months ago.
FRDM KL46Z board not getting detected.
The board was working fine until i tried using the SDA of one board to program other. Now both the boards are not getting detected on the pc even when I disconnected the inter-board SDA connections. Please help
Question relating to:
Last updated: 30 Jun 2020
The FRDM-KL46Z is an ultra-low-cost development platform enabled by the Kinetis L series KL4x MCU family built on the ARM® Cortex™-M0+ processor. Features include easy access to MCU I/O, battery-ready, …
Be the first to answer this question.
Adding pictures of you wiring or a schematic will allow people to better help you. Also - by providing more detail and clearly stating what you are trying to do - I think you'll get more help with a question like this :)
posted by Sam Grove 03 Oct 2014I am trying to program one FRDM microcontroller using the SDA of another microcontroller. I connected pin 4 of the SDA (J11) to pin 2 of J18 of the target uC. Also I connected pins 2 and 10 of J11 of the 2 uCs as specified in the datasheet. I didnt cut the connection between J11 and J18 of the source controller. As I powered up, the uCs showed bootloader error ( 8 flashing LEDs). So I disconnected the connections between the 2 uCS. But now both the uCs are not even detected on my pc.
posted by green rosh 03 Oct 2014