mbed

The output is normalised to 1, so simply multiply the float value returned from the analogue read by 1024.

Well, I've been looking through the datasheet, user manual, and LPC1768 header.

I serously can't find the sucker, but it should be possible to change the setting.
It's an 12 bit SAC btw. :-)

Lerche

Igor Skochinsky wrote:
Yeah, I don't see any mention of 10-bit mode either. Why would you need it anyway? BTW, instead of using floating-point multiplication, you can take the 16-bit value returned by read_u16 and shift it four bits to the right.

That's actually a much better idea! The M3 doesn't have an FPU does it?

I want the 10bit resolution because with 12 bit the max sampling freq is 200KHz, in 10bit mode the max sampling rate is 500KHz.

I don't really need 12 bit, but I need more speed :)

Igor Skochinsky wrote:
Yeah, I don't see any mention of 10-bit mode either. Why would you need it anyway? BTW, instead of using floating-point multiplication, you can take the 16-bit value returned by read_u16 and shift it four bits to the right.

Uhhmm right it must be the reason :)

Thanks for the information, I'll try to use the ADC in interrupted mode at 200KHz and see if it's enough. If not i'll take an external ADC.

hello,

I am facing with stability in the ADC value .

I put a variable resistor betwen the Vout 3.25V and ground. The 3rd pin is connected to the P15  (analog input).

after moving the cursor I have 1.6V for example on the P15.

I send the result to the serial via USB PC  and in Tere Term

P15 value 19204 P15 value 18116 P15 value 19476 P15 value 20132 P15 value 18420 P15 value 18420 P15 value 20196 P15 value 19396 P15 value 18116

Here is the code used

#include "mbed.h"

AnalogIn Temperature(p15);

Serial pc(USBTX, USBRX);// tx, rx

int main() {

unsigned int LUI_Temperature=0;

while(1) {   LUI_Temperature = (Temperature.read_u16());

pc.printf("P15 value %d",LUI_Temperature);

}

}

I do not understand why I have some much variation in the value get from ADC.

How are coded the 12 bits return by ADC in the variable  ( bit 15 to bit 4o or bit 11 to bit 0 )?

If some has some idea?

Additional information, when you put 0V impossible to get something close to !

When you put 3.3V impossible to get something close to 65535 !

A+

Sares

How many ohm is your variable resistor ?

You must respect the max impedance.

It is a 10K variable resistor.

Hello, am new to mbed environment and lately am working on a project to read and store a strain gauge value. everything seems working except ADC always put zero to the output all the time. below is part of the code for ADC conversion

ADC adc (150000,1); .... while (1) { adc.setup(p20,1); adc.select(p20); adc.start(); while(!adc.done(p20)); wait(1); fprintf (fpp,"%05f\n\r", adc.read(p20)); }